#DRIVERPACK SOLUTION 14 MEGA FULL#
This weakens the derailleur's attachment point and can lead to shifting flex or a greater chance of full on derailleur failure if you snag it on branches, debris, etc.
Note too, that the washer must be quite thin, as it takes away from the available threading between the derailleur and the hanger. You'll have to readjust the L/H limits again when using the washer method. This basically moves the derailleur's base position slightly outward (away from the wheel), helping to get the chain onto the small cog. STEP 5: Preparation for Decision: This step typically takes 7-14 days to. In these cases, a (very much non-official) solution is to take off the derailleur, find a thin washer that matches the dropout size, and thread the derailleur back onto the hanger with the washer in place (between the derailleur and the hanger). While LEGO and Mega Bloks bricks fit together, the holes in LEGO studs do not. Since you say it's a new derailleur though, the spring is probably fine.Įven with new derailleurs, however, sometimes they just can't get into the relaxed position enough for smooth and consistent shifts into that small cog. give it a cleaning and lube, which might help it go into the fully relaxed position (and thus help get that chain down onto the small sprocket). If your L/H limits are fine (which you can test by pushing the derailleur by hand to the limit positions) and you still have a problem dropping into the smallest cog, there are a few possible solutions.įirst is to make sure your main derailleur spring(s) isn't rusty. They are usually marked with "L" and "H" symbols on the derailleur, and are likely close to each other.
These are the screws that define the limits of the derailleur in terms of how far in (towards the wheel) or out (away from the wheel) the derailleur can travel.
If so, (actually, even if it's the largest cog), the screw you first want to adjust (before making changes to the B-limit screw) is the high (or low) limit screw. And by first gear, do you mean the smallest (i.e.
0 kommentar(er)
